A practical reference on degree of hydrolysis: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-06-11 and is reviewed periodically as new material appears.
Whey protein hydrolysate is a dairy ingredient made by treating whey protein with proteolytic enzymes. The starting material is whey, the liquid remaining after cheese or casein production, and its main proteins include beta-lactoglobulin, alpha-lactalbumin, and bovine serum albumin. Enzyme action breaks peptide bonds, producing shorter peptides and some free amino acids. The result is not a single uniform substance; composition depends on whey source, enzyme type, hydrolysis conditions, and downstream filtration. Hydrolysates are often described by average peptide length or degree of hydrolysis rather than by one fixed molecular weight.
Compared with whey protein concentrate or isolate, hydrolysate has a smaller average peptide size and a higher proportion of low-molecular-weight fractions. This change can affect solubility, viscosity, osmolality, taste, and foam formation. Some hydrolysates are bitter because hydrophobic peptides are exposed during cleavage. The term hydrolysate does not indicate a guaranteed peptide profile; two products with the same reported hydrolysis value can differ in peptide sequence and residual intact protein. Commercial specifications usually state protein content, moisture, ash, fat, and microbiology, while peptide distribution may be reported as a range.
Whey protein hydrolysate appears in infant formula, sports nutrition, and clinical nutrition. In infant formula, extensively hydrolyzed products are used when a reduced allergenicity is desired, though not all hydrolysates are hypoallergenic. In sports products, the ingredient is marketed for rapid amino acid delivery, but the practical advantage over intact whey protein remains debated. Research often compares hydrolysate with isolate or concentrate for absorption kinetics, muscle protein synthesis, and gastrointestinal tolerance. Regulatory categories differ by country, and label terms such as partially hydrolyzed or extensively hydrolyzed are defined in some jurisdictions but not others.
Testing hydrolysate powders typically begins with proximate analysis for moisture, ash, fat, and total nitrogen. Protein content is calculated from nitrogen using a conversion factor, most often Kjeldahl or Dumas combustion. Peptide size distribution is assessed by size-exclusion chromatography, reversed-phase HPLC, or mass spectrometry. Sodium dodecyl sulfate polyacrylamide gel electrophoresis can show residual intact protein bands. Free amino groups may be quantified by colorimetric assays to estimate cleavage extent, though different methods and laboratories are not always directly comparable.
Dry hydrolysate powders are generally stable when kept cool, dry, and sealed, while moisture uptake can cause caking, Maillard browning, and loss of solubility. Higher temperatures accelerate these changes and may alter flavor. Recommended storage conditions often fall between 15 and 25 degrees Celsius with relative humidity below 60 percent. Once reconstituted, liquid hydrolysate solutions support microbial growth and may develop bitterness or haze over time. Packaging in moisture-barrier containers with desiccants helps maintain quality during transport and warehouse storage.
| Property | Value | Notes |
|---|---|---|
| Appearance | Off-white to light tan powder | Color can vary with hydrolysis and drying |
| Protein content | 70–90% dry basis | Lower if ash, lactose, or moisture remain |
| Degree of hydrolysis | Typically 5–35% | Partially and extensively hydrolyzed types differ |
| Solubility | Water-soluble | High across common food pH ranges, though peptide dependent |
| Common synonyms | Whey hydrolysate; hydrolyzed whey protein | Sometimes abbreviated WPH on labels |
Whey protein hydrolysate is a dairy ingredient made by treating whey protein concentrate or isolate with proteases that cleave peptide bonds. The resulting mixture contains shorter peptides and free amino acids than intact whey protein. Commercial products vary widely in average peptide length, residual intact protein, lactose, fat, and minerals. The term hydrolysate does not imply a single fixed composition, because enzyme choice, reaction time, pH, and temperature all shape the final peptide distribution. Products are often described by degree of hydrolysis, a percentage estimate of cleaved peptide bonds.
Production begins with pasteurized whey, which is concentrated and sometimes defatted or demineralized before hydrolysis. Food-grade proteases, such as trypsin, chymotrypsin, pepsin, or microbial enzymes, are added under controlled conditions. After a target degree of hydrolysis is reached, the enzymes are inactivated by heat or pH adjustment. The liquor is then clarified, concentrated, and dried, usually by spray drying. Ultrafiltration or diafiltration may remove residual enzymes, salts, or very small peptides, depending on the intended specification.
Routine quality control for hydrolysate powders includes total nitrogen or protein content by Kjeldahl or Dumas combustion, moisture by oven or Karl Fischer titration, ash, and mineral profiles. Microbiological tests typically cover total aerobic counts, yeasts, molds, and specified pathogens according to regional food safety rules. Amino acid analysis can quantify free amino acids and peptide-bound residues after hydrolysis. For products intended for special populations, additional tests may target residual lactose, fat, or specific allergenic proteins. Specifications are set by the manufacturer and may exceed general food-grade requirements.
Hydrolysate powders are hygroscopic and can absorb moisture during storage, which may promote caking, browning, and loss of solubility. Cool, dry conditions and sealed packaging slow these changes, while high humidity and warm temperatures accelerate Maillard reactions between peptides and residual sugars. Liquid hydrolysates are more perishable and often require refrigeration or preservatives. Shelf-life studies usually monitor moisture, color, solubility, free amino groups, and microbial load over time. Stability depends on residual lactose, water activity, packaging barrier properties, and the initial peptide profile.
Composition reflects the whey source and the extent of hydrolysis. Beta-lactoglobulin and alpha-lactalbumin fragments are common, and sweet whey may contribute glycomacropeptide. The amino acid profile remains broadly similar to intact whey protein, but peptide size affects how quickly nitrogen appears in blood after ingestion. Bitter notes often arise from short peptides with hydrophobic residues. Hydrolysates are used in sports nutrition, infant formula, and clinical nutrition, though effects on muscle, immunity, or allergy risk are separate research questions rather than guaranteed properties.
Whey protein hydrolysate is derived from whey, the liquid byproduct of cheese-making or casein coagulation. It consists of peptides and free amino acids produced when peptide bonds are cleaved by enzymes or acid. Hydrolysis lowers the average molecular weight and can change solubility, viscosity, and bitterness. The degree of hydrolysis indicates the proportion of peptide bonds broken and distinguishes partial from extensive hydrolysates. Commercial ingredients vary widely in peptide size, mineral content, and lactose level.
Production usually starts with whey protein concentrate or isolate. The material is dissolved, pasteurized, and adjusted to conditions that favor a chosen protease, such as trypsin, pepsin, or papain. Enzyme choice, pH, temperature, and reaction time determine peptide length, terminal residues, and functional behavior. After hydrolysis, the enzyme is inactivated by heat or pH change, and the liquid is clarified, filtered, concentrated, and dried. Membrane filtration can further fractionate peptides and remove some minerals or lactose. The final powder is typically spray-dried.
Aviation Safety Network Established in 1996. The ASN Safety Database contains descriptions of over 15800 airliner, military and corporate jet aircraft accidents/incidents since 1921. Bureau of Aircraft Accidents Archives Established in 2000. The B3A contains descriptions of over 22,000 airliner, military and corporate jet aircraft accidents since 1918. National Transportation Safety Board Aviation Accident Synopses – by month Aviation Statistics Statistical and geospatial analysis of general aviation accidents. Aviation Accidents App Access the NTSB Aviation Accidents Database and Final Reports from all over the world on your mobile device Aviation Accidents Map Explore an interactive map showcasing airplane crash sites Air Crash Map | Interactive Aviation Accident Database
Once the substrate is bound and oriented to the active site, catalysis can begin. The residues of the catalytic site are typically very close to the binding site, and some residues can have dual-roles in both binding and catalysis. Catalytic residues of the site interact with the substrate to lower the activation energy of a reaction and thereby make it proceed faster. They do this by a number of different mechanisms including the approximation of the reactants, nucleophilic/electrophilic catalysis and acid/base catalysis. These mechanisms will be explained below.
Founded in 1984, Bio-Synthesis, Inc. was known as OCS Laboratories and was one of the first companies providing commercially available synthetic oligonucleotides to the biomedical research community worldwide. It was the first producer of commercially available synthetic DNA and became a producer of synthetic peptides in 1985, and became the only company to provide both synthetic DNA and peptide under one roof. Also in 1985 the process, now known as PCR, was discovered by Mullis et al. A key activity for Bio-Synthesis was to synthesize large number of PCR primer thus assisting and solidifying the early adoption of this now common and crucial process in biology.
Sources: en.wikipedia.org
Annals of Clinical Biochemistry is a bimonthly peer-reviewed scientific journal covering all aspects of clinical biochemistry. The editor-in-chief is Michael J Murphy (University of Dundee). It was established 1960 and is published by SAGE Publications on behalf of The Association for Clinical Biochemistry and Laboratory Medicine. The journal is abstracted and indexed in: According to the Journal Citation Reports, its 2012 impact factor is 1.922, ranking it 12th out of 31 journals in the category "Medical Laboratory Technology". Official website
The polar, uncharged amino acids serine (Ser, S), threonine (Thr, T), asparagine (Asn, N) and glutamine (Gln, Q) readily form hydrogen bonds with water and other amino acids. They do not ionize in normal conditions, a prominent exception being the catalytic serine in serine proteases. This is an example of severe perturbation, and is not characteristic of serine residues in general. Threonine has two chiral centers, not only the L (2S) chiral center at the α-carbon shared by all amino acids apart from achiral glycine, but also (3R) at the β-carbon. The full stereochemical specification is (2S,3R)-L-threonine. Because of the presence of phenolic hydroxyl group with a pKa = ~10, tyrosine is best classified as a neutral polar amino acid, but with amphipathic character that makes it less polar than classical small polar amino acid residues. Nonpolar amino acid interactions are the primary driving force behind the processes that fold proteins into their functional three dimensional structures. None of these amino acids' side chains ionize easily, and therefore do not have pKas.
The Swiss company GlycArt Biotechnology developed a system using CHO cells, where the cells were engineered to overexpress an enzyme called GnTIII. The effect of this overexpression is to block the formation of fucosylated oligosaccharides on the expressed antibodies. This technology was first reported in 1999 and was the basis of GlycArt Biotechnology. Roche acquired GlycArt in 2005 in order to acquire technology to afucosylate antibodies. GlycArt Biotechnology had been founded in 2000 as a spin-out company of the Swiss Federal Institute of Technology in Zurich. The first commercial product from the GlycArt acquisition was obinutuzumab, which as Gazyva gained FDA approval in November 2013 for the treatment of chronic lymphocytic leukemia. Kyowa Hakko Kirin's "Potelligent" platform uses a CHO cell line in which FUT8 has been knocked out, and which produces antibodies with little to no fucose in the Fc region. The company gained marketing approval in Japan in April 2012 for a monoclonal antibody drug called mogamulizumab which was developed using the platform. The Company's technology was first reported in 2004.
Sources: en.wikipedia.org
It is made from whey, the liquid byproduct of cheese or casein manufacture. The whey protein is treated with enzymes that cleave peptide bonds. The resulting mixture contains peptides of varying lengths plus some free amino acids.
Whey protein isolate is largely intact protein with a high protein content by dry weight. Hydrolysate has been enzymatically broken into smaller peptides, which can change taste, osmolality, and absorption behavior. Both can have similar total amino acid content, but their peptide profiles differ.
No. Hypoallergenic status depends on the extent of hydrolysis and the residual allergenic protein fragments. Regulatory bodies set specific criteria for products labeled hypoallergenic or extensively hydrolyzed. A hydrolysate not meeting those criteria may still contain allergenic epitopes.
Keep the powder sealed in a cool, dry place away from direct sunlight and strong odors. Typical targets are 15 to 25 degrees Celsius and low relative humidity. After opening, use within the manufacturer's recommended period.